Loading... Please wait...

Our Newsletter

Duct, Silicone Air Inlet, Black, Red & Blue, 90~95 [12A]

  • Image 1
  • Image 2
  • Image 3
2.75 LBS
Calculated at checkout

Product Description

Silicone Air Inlet Duct. Fits 90~95 ZR-1 LT5 engine. "Jerrys Gaskets" branding can be turned to the underside if preferred, during installation. Developed for higher capacity air flow and to not collapse under hot, wide open throttle conditions as the stock accordian air duct is prone to do.

The stock, original duct clamps are not quite large enough to use with the thicker silicone duct.  Apart from the size issue, the stock clamps are not strong enough nor are they designed specifically with rolled edges and smooth underside to protect silicone or rubber. We highly recommend our SS Clamps, designed for this specific application, to protect your new duct. Inproves the appearance and keep it securely in position. Clamp, Inlet Air Duct, SS 1990-95 [4E3].

NOTE: The air duct is purposely sized to be slightly longer than the stock air duct.  We recommend that it be fully installed with the Air Horn end correctly located with the clamp fully tightened to hold it securely in position.  The duct & clamp will clear the AC Compressor clutch when the clamp is fully tightened.  Then install the Filter Housing and position the clamp to its final position.  If the duct appearance is too long, simply mark a line parallel to the clamp at the distance needed for trimming reference.  Remove the duct and simply trim the excess away with a sharp blade and re-install. 




Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the Duct, Silicone Air Inlet, Black, Red & Blue, 90~95 [12A] to your wish list.